circuit coll

How to Build a Efficient Negative Voltage Regulator Circuit Diagram. This simple Efficient Negative Voltage Regulator Circuit Diagram is One v;ay to provide good negative-voltage regulation is with a low-dropout positive-voltage regulator operating from a well-isolated secondary winding of switch-mode circuit transformer. The technique works with any positive-voltage regulator, although highest efficiency occurs with low-dropout types. 

Under all loading conditions, the minimum voltage difference between the regulator ViN and VoUT pins must be at least 1.5 V, the LT1086`s low-dropout voltage. Efficient-negative-voltage-regulator Rating: 7.00/10 (23Votes cast)Category: Power Supply Circuits / AC to DC & DC to DCViews: 3Rank: 5One v;ay to provide good negative-voltage regulation is with a low-dropout positive-voltage regulator operating from a well-isolated secondary winding of switch-mode circuit transformer. 

The technique works with any positive-voltage regulator, although highest efficiency occurs with low-dropout types. Under all loading conditions, the minimum voltage difference between the regulator ViN and VoUT pins must be at least 1.5 V, the LT1086`s low-dropout voltage.Efficient-negative-voltage-regulatorIf this requirement isn`t met, the output falls out of regulation. 1vo programming resistors, R1 and R2, set the output voltage to 12 V, and the LT1086`s servo the voltage between the output and its adjusting (ADJ) terminals to 1.25 V. 

Capacitor C1 improves ripple rejection, and protection diode D1 eliminates common-load problems. Since a secondary winding is galvanically isolated, a regulator`s 12 V output can be referenced to ground. Therefore, in the case of a negative-voltage output, the positive-voltage terminal of the regulator connects to ground, and the -12 V output comes off the anode of Dl. The ViN terminal floats at 1.5 V or more above ground.

Simple Efficient Supply Splitter Circuit Diagram. In this application, the Vl-7660 is connected as a voltage splitter. Note that the normal output pin is connected to ground and the normal ground pin is used as the output. The switches that allow the charge pumping are bidirectional; therefore, charge transfer can be performed in reverse. 

The 1-MO resistor is used to avoid start-up problems by forcing the internal regulator on. An application for this circuit would be driving low-voltage, ± 7.5 Vdc, circuits from ± 15 Vdc supplies, or low-voltage logic from 9 to 12 V batteries.